Dustcontrol DC 1800 Original Instructions

DC 1800 - 13 Part No 94114-H
Operation
DC 1800: Connect the unit to a suita-
ble power source, note requirements
on the ID plate. If an extension cord is
to be used, only waterproof cords are
acceptable.
DC 1800 Autostart: Connect the
subject electric tool to the electrical
outlet on unit. Set the selector switch
to the AUTO position. The unit will
start automatically when the subject
tool is started. For manual start of
the unit, set the selector switch to the
MAN position.
The DC 1800 is equipped with a fi lter
indication lamp that indicates when
the fi lter needs cleaning or changing.
The fi lter is genereally cleaned once or twice daily
during normal continuous operation. The unit must
be in operation to perform fi lter cleaning. Loose the
tube from the suction pipe and press the plastic
cage against the black stop head on the exhaust
channel so that maximum pressure is created in the
cyclone.
Open the port on the side o the unit three to six
times. This reverse pulse of air cleans the fi lter.
The machine can be used both with or without col-
lection sack.
The collection sack should only be changed after
the cleaning of the fi lters. The collection sack must
be tied off when it is removed from the container.
Use only original Dustcontrol spare parts. There
should not be any fold on the container border.
The tightness make that the sac does not being
sucked.
When remounting the motor top and the cyclone
on the container the hose inlet should be pointed
according to the picture beside.
For best result:
- Secure that no air is between the bag and
the barrel when you apply the bag.
- Secure that no air is leaking between the
bag and the barrel when you are using the
machine.
ENGLISH

Dustcontrol DC 1800 Specifications

General

Brand	Dustcontrol
Model	DC 1800
Category	Vacuum Cleaner
Language	English