1312
Ionizer
This device comes with a built-in ionizer. The
ionizer released negative ions to capture tiny
airborne particles and pull them inside the lter.
The ionizer is o by default and can be switched
on by pressing the Ionizer icon on the device or
switching it on in the Duux App.
Night mode
Once the device is set in night mode, the LED
indicators and display will automatically turn o
after 10 minutes. Press any button to reactivate the
controls and display.
the lter depends on the air quality and usage of
the device (approx. 4-6 months) (art. no. DXPUF06)
Note: Please dispose used lters as non-
combustible garbage.
Maintenance before storage
Switch o the device and remove the plug from
the wall outlet.
Cover the device with a plastic bag, and keep
in a dry place. Always store it upright as
placement in a at or reverse manner may
cause a fault to the device.
Spare parts
Spare parts and accessories can be requested at
the point of purchase or local distributor
EN
Connect to WIFI
Once registered, click “add duux device” on the
main screen or use the “+” button in the top
right corner to add a new device.
Search for “Bright” and press to continue
Connect to your preferred WiFi network and
enter the corresponding password
Follow the instructions in the app to complete
the pairing process.
Filter
The HEPA lter cleans the air from smaller
particles. The activated carbon lter removes
harmful gases and toxics such as smoke,
chemicals, VOC’s and bacteria.
PM2.5 sensor
The pollution degree of the air is sensed by the
sensor, and the pollution condition is displayed by
means of the indicator light of air pollution degree.
In the AUTO speed mode, the device automatically
selects the optimal speed according
to the pollution degree. Detected pollutants:
PM2.5, dust, pollen, mold, pet dander. PM2.5 is
measured in microgram per cubic meter. The
actual measured value can be viewed in the Duux
App.
Important: Be sure to remove the power plug
from the outlet before carrying out maintenance.
Important: Do not soak or immerse the power
plug or the device in water.
Important: We recommend weekly
maintenance for optimal eciency.
Cleaning
• Please use a soft dry cloth to wipe dust o the
body; If the surface is too dirty, it is better to wipe
it clean with a damped cloth mixed with neutral
detergent.
• Don’t use gasoline, thinner and any others
chemical substances as it will easy damage the
surface.
Pre-lter
To remove large dust particles on the pre-lter
body, use a vacuum cleaner with soft brush
extension to gently clean the surface.
HEPA- and activated carbon lter
The lter replacement indicator will let you know
when it’s time to replace your lter. The lifespan of
4. Maintenance
replacement
1
2
4
3
2
1
To Next Page
Loading...
