To Next PageTo Next Page
Need help?Do you have a question about the DVA T8 and is the answer not in the manual?
Details the three class D amplifiers, high efficiency, and static cooling of the DVA T8.
Explains the DIGIPRO G2 amplifier's power supply circuits and SMPS technology for 100-240V operation.
Describes the 8" neodymium woofer with 2.5" voice coil for high SPL and low frequencies up to 70Hz.
Details the 6.5" neodymium midrange with acoustic chamber and horn loading.
Describes the two 1" neodymium drivers positioned vertically for optimized coverage.
Details the XLR input connector and parallel XLR link output connector.
Explains the LIMITER, SIGNAL, MUTE/PROT, and READY indicator lights.
Describes the control for adjusting the signal amplifier input sensitivity.
Covers RDNET data input/output connectors and status indicators.
Recommendations for downloading DVA Network and USB Manager software.
Information on the acoustical simulation software for DVA systems.
Details the Remote Preset Active indicator and DSP Preset rotary switch.
Describes the Service Data USB connector and Mains Input/Output sockets.
Details the front grille, cooling system, and power-on sequence.
Explains how the system signals and handles failures.
Describes connecting to mains supply via Neutrik POWERCON.
Details status indicators for Power ON, Normal use, Partial fault, and Total fault.
Explains indicators for First and Second thermal thresholds.
Describes status indicators for RDNET not active and RDNET connected.
General warnings and cautions for secure loudspeaker installation.
Details the DRK 10 flybar's maximum load for DVA T8 configurations.
Details the DRK 10 flybar's maximum load for DVA S10dp configurations.
Details the DRK 10 flybar's maximum load for DVA S1518N configurations.
Provides examples of calculating total weight for mixed system configurations.
Information on the DRK 20 flybar system and its safety compliance.
Prohibits changes to flybar structure and accessories to avoid failure risks.
Emphasizes using only original parts and following installation instructions.
Example of calculating total weight for mixed suspension of DVA T8 and DVA T12.
Example of calculating total weight for mixed suspension of DVA T8 and DVA S10dp.
Example of calculating total weight for mixed suspension of DVA T8 and DVA S1518N.
General| Type | Line Array Module |
|---|---|
| MF Voice Coil | 2" |
| LF Voice Coil | 2.5" |
| Amplifier Technology | Class D |
| HF Amp | 350 W RMS |
| MF Amp | 350 W RMS |
| LF Amp | 700 W RMS |
| Cooling | Convection |
| Processor | DSP 56 bit |
| AD/DA Converter | 24 bit/48 kHz |
| Limiter | Dual Active, Multiband, RMS, Peak, Thermal |
| Crossover Frequency MF-HF | 1.6 kHz |
| Crossover Frequency LF-MF | 310 Hz |
| Signal Input | 1x XLR fem, balanced |
| Signal Output | 1x XLR male, balanced |
| Power Socket | PowerCON TRUE1 |
| Voltage Range | 220-240 V or 100-120 V (Automatic Switch) |
| Housing | Multiplex birch plywood |
| Width | 676 mm (26.61 in) |
| Height | 240 mm (9.45 in) |
| Depth | 450 mm (17.72 in) |
