Humidity Settings
For adjusting the sensitivity of the system to an
air supply which is more humid than the air inside
the home. A higher setting will mean the system
reacts more quickly to a humid air supply then
remains o for a period of time and until the air
supply is dry enough to continue ventilating your
home. The DVS® technician sets this function
when the system is installed, however, this
setting can be increased or decreased.
Note: To prevent nuisance stopping and starting
(oversensitivity) the DVS® is programmed to
allow some minor higher air supply humidity
readings before it will stop ventilating. Please call
DVS® on 0800 387 387 if you need assistance
and before you adjust these settings.
Humidity settings
Touch settings icon then – SETTINGS >
HUMIDITY CONTROL – Scroll the Humidity
sensitivity or Humidity time up or down to the
level you wish - OK > EXIT
CO
2
Sensing & Control
For enabling or disabling the CO
2
control function. The DVS®
technician enables this function and pairs the sensor(s) when the
system is installed, however, this function can be Enabled (turned
on) or Disabled (Turned o).
CO
2
Enable / Disable
Touch settings icon then – SETTINGS > CO
2
CONTROL > ENABLE
(touch the Enable/Disable slide switch icon to change to Enable or
Disable) - OK > EXIT
CO
2
Sensors - connecting to the system
The DVS® Connect range has one remote plug in CO
2
sensor as a
standard inclusion. Extra sensors can be tted with a maximum
of four sensors per system. When multiple sensors are tted the
system uses the average CO
2
reading across all sensors to activate
a higher ventilation rate when the average CO
2
concentration rises
above 1000ppm.
Connecting to the system
Plug in the CO
2
sensor in your room of choice and turn on the switch
on the plug so the sensor has power to it (leave the sensor plugged
in and turned on at all times) – Go to the control panel and touch
the settings icon
then – UTILITIES > MANAGE CO
2
> ADD SENSOR
– Go back to the sensor, hold in (you will need to use a toothpick,
matchstick, sharpened pencil or similar) the recessed button on the
sensor for 5 seconds until the green light emitting from the bottom
of the sensor holds solid (this starts the pairing process) – Go back to
the control panel and when the pairing is complete - EXIT > EXIT
If the system did not have a CO
2
sensor connected previously you
will notice a new bar appears on the home screen. This is the CO
2
level indicator mentioned above in the “On your home screen”
section.
WiFi connection and software upgrades
To check for upgrades or reconnect to your WiFi
Touch the WiFi icon then choose – WiFi Scan or Check for upgrades (whichever is applicable) – then follow the instructions.
Clock
To manually adjust the clock
Touch the clock numbers
11:20
then - SET DATE AND TIME > EXIT
Filter change reminder reset
Touch settings icon
then – SETTINGS > FILTER OPTIONS > NEW FILTER INSTALLED > YES > EXIT > EXIT
Note: This setting is intended to reset the lter reminder on your system. Resetting this means that you will receive a
reminder to change your lter again, on the control panel, in 12 months.
For further assistance please call DVS
®
on 0800 387 387 4
To Next Page
Loading...