Section 1: Leg Assembly and Height Adjustments
Section 1.1: Leg Assembly
1. Loosen wingscrew on the clamp at top of base section.
2. Pull legs outward far enough to allow the clamp to contact memory lock.
To open or close the legs, loosen the drumkey screw on the leg memory lock located on
the bottom tube section. Loosen the wingscrew on the clamp at top of base section and
adjust the tripod to achieve the desired position. Then tighten the clamp and memory
1. Loosen the memory locks and wingscrews on tube receivers.
2. Raise or lower the upper tubing section to the desired position.
3. Tighten memory locks and wingscrews on tube receivers.
Section 2: Snare Drum Basket Adjustments
Section 2.1: Snare Drum Basket
1. Loosen the TechLock™ drumkey screw and Position Reset handle on large basket
Note: The Position Reset Handle is spring activated. To operate, grasp the handle with
your ngers and use your thumb to press on the button in the center of the handle
while pulling the handle away from the tilter. Reset the handle to a more comfortable
2. Rotate the basket and positioning rod so that the basket is in its upright position
and tighten the Position Reset Handle.
3. Open the basket by rotating the large knurled knob at the bottom of the basket
4. Place snare drum on basket so that it rests on the rubber grips.
5. Tighten the basket by turning the large knurled knob counterclockwise.
Note: Although a tighter basket will make your drum more secure it may also choke
the drum. Experiment to nd the best tightness for your situation.
6. Tighten the TechLock™ drumkey screw.
Section 2.2: Drum Positioning
By loosening the Position Reset Handles and TechLock™, the angle, rotation and offset
position of the 9300 can easily be adjusted.
a. Angle/Rotation - The basket can be tilted in any direction to achieve the most desir-
b. Distance Offset - The position of the Positioning Rod can be adjusted to allow for
an increased offset between the basket and the stand which makes the 9300 more
adaptable to the position of other stands, drums and pedals.
Section 2.3: Basket Removal
For easier pack up and more consistent set up, the 9300 features a removable basket.
To remove the basket from the stand, collapse the basket 1/2 way and loosen the two
drumkey screws that are located at the point where the basket is attached to the posi-
tioning rod. You can now remove the basket from the rod. This allows you to pack up the
stand while maintaining your position settings.
Remove the stand and all packing materials from the box, then follow these instructions to set up and adjust your stand to t the way you play.
universal position adjustment
Instructions and parts identi cations also apply to 9300L and 9303 stands.
To Next Page
Need help?
General
