12
English
the polishing with circular or cross movements with
little pressure.
• Turn off the power tool, remove polishing sponge 11
and attach polishing bonnet 12 to sanding plate 6.
• Using a soft cloth, remove excess polishing agent
from the machined surface and perform nal polishing
with polishing bonnet 12, with circular or cross
movements with little pressure.
• After the work is completed, rinse polishing
sponge 11 and polishing bonnet 12 in warm water with
a cleaning agent. Do not use solvents.
• Squeeze (do not wring) polishing sponge 11 and
polishing bonnet 12. Allow them to dry, stretching
them on at surface, adhesive surface on the bottom.
Attention: do not store the polishing accessories
unless they have dried out completely.
Installation and regulation
of power tool elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Cleaning of the power tool
An indispensable condition for a safe long-term
exploitation of the power tool is to keep it clean.
Regularly ush the power tool with compressed air
thought the ventilation slots 3.
After-sales Service and Application Service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts. Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com.
•
Transportation
of the power tools
Categorically not to drop any mechanical impact on
the packaging during transport.
• When unloading / loading is not allowed to use
any kind of technology that works on the principle of
clamping packaging.
Environmental
protection
Recycle raw materials instead of
disposing as waste.
Power tool, accessories and packaging should be
sorted for environment-friendly recycling.
The plastic components are labelled for categorized
recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
The manufacturer reserves the possibility to introduce changes.
To Next Page
Loading...
