9
ASSEMBLY & SETUP
Use the following procedures to unpack and assemble your Strength Equipment manufactured by Spirit Fitness.
UNPACKING & PARTS
1. Position the shipping carton so the Heavy End is located at the bottom.
2. Cut the straps then lift the box over the unit and unpack. Remove all parts from the shipping carton and foam inserts, and verify
that all parts are included in your shipment:
3. Locate the hardware package. The hardware is separated into four steps. Remove the tools first. Remove the hardware for
each step as needed to avoid confusion. The numbers in the instructions that are in parenthesis (#) are the item number from
the assembly drawing for reference.
NOTE: All tools required to assemble the Strength Equipment are included within the packaging.
Take time now to enter your Strength Equipment serial number in the space below.
(Serial number is located on the center tube, see page 7).
Serial No._____________________________________________
NOTE: If you are missing any of the parts listed above, inspect the packing material and the box for items that may have been
overlooked.
If parts are missing, or if you have any operational questions, please call your local Spirit Fitness’s Service department or the
distributor whom sold you the product. Please see page 4 for a listing of international corporate offices and locate the office
nearest you. Have your serial number ready.
CAUTION: Damage to the Strength Equipment during assembly is not covered as part of the limited Spirit Fitness warranty. Take
care not to drop or lean the Strength Equipment on its side. Carefully stand the Strength Equipment up in the normal upright
position on a stable surface so it will not tip over during assembly.
Protect the environment by not disposing of this product with household waste. Check your local authority or approved waste
center for recycling advice and facilities.
PRODUCT SPECIFICATIONS
To Next Page
Loading...