ACCU-CAL™ 160 Radiometer User Guide
CAUTION: Exposing the display window to high UV radiation will damage the display.
Figure 7. Start Measurement Screen
Figure 8. Optics Window (Located on the Backside of the Radiometer)
When the radiometer exits the curing chamber, the measurement sequence will still be
running. To end the sequence, press the right button.
The measurement is stopped when the device memory is full, and a warning message is shown
if this is the case. The low sample rate corresponds to approximately 1,300 seconds of
measurement time, the high sample rate to approximately 13 seconds.
To Next Page
Loading...