BlueWave
®
AX-550 Flood Lamp Mounting Stand Kit (43410)
Unpacking and Setup Instructions
1. Remove the stand and carriage from the packaging.
2. Remove the cap and 2 fasteners from the stand’s upright. These are push-in fasteners, not screws, and can
easily be removed by pushing upward on the plate (Figure 1).
Figure 1. Remove Cap and Fasteners
Figure 2. Attach the Carriage
3. Using a 4-mm hex key, attach the carriage to the emitter using the screws supplied with the carriage. (Figure 2)
4. Slide the carriage onto the stand upright, being sure to align bearing pads and t-nut into slot (Figure 3).
Figure 3. Slide Carriage into Stand
To Next Page
