dymax BlueWave MX Series

Other manuals for dymax BlueWave MX Series

Quick Start Instructions2 pages

Unpacking And Setup Instructions2 pages

Questions and Answers

S
smithbreannaAug 14, 2025
Why does my dymax BlueWave MX Controller system suddenly stop producing light?
- R
  reginald65Aug 14, 2025
  If the dymax BlueWave MX Controller system suddenly stops producing light, it could be due to a few reasons: * An over-temperature shutdown may have been triggered. Verify the alarms. * The footswitch might be defective. Try activating the unit using the front control panel. If it works, replace the footswitch. * The interlock could be open. Ensure the interlock jumpers are in place and check the PLC command structure for PLC mode.
T
Tonya HernandezAug 23, 2025
How to fix low-intensity light from dymax BlueWave MX Controller emitter?
- M
  matthewcolemanAug 23, 2025
  If your dymax BlueWave MX Controller emitter is only providing low-intensity light, here are a couple of things to check: * The LED intensity adjustment might be set to the minimum. Increase the LED intensity setting on Admin Settings or I/O input for PLC Mode. * The lens optics may be contaminated or dirty. Clean the surface of the lens.
A
Amber KellerNov 2, 2025
What to do if my dymax BlueWave MX Controller emitter does not produce light?
- Q
  qflemingNov 2, 2025
  If the dymax BlueWave MX Controller emitter isn't producing light, there are several potential causes: * The LED intensity might be set too low. Try increasing the LED intensity setting. * The LED cycle time could be set to 0 seconds, which sets Manual Mode and requires a trigger. * The interlock might be open. Verify the interlock jumpers are correctly placed and check the PLC command structure for PLC mode. * The interface cable connections may be loose or damaged. Inspect the connections and the condition of the interface cable. * The trigger setting may not match the input. Ensure the trigger setting on the Admin screen matches the desired input trigger channel. * The LED head might not be connected to the correct port/channel. Check that the head is connected to the inten...