The Frequencer
®
instruction manual
8
[4_C] CONTROL UNIT
CONNECTIONS
A_ Plugging in the power
supply.
B_ On/Off Push Button
.
A
B
[5] Treatment in a
controlled environment
The Frequencer
®
V2x should not be used when the
temperature
exceeds
104
o
F (40
o
C) or goes below 4 1
o
F
(5
o
C). If the device was exposed to
an
extreme
temperature
for a prolonged period (e.g. after a long car
ride)
let
it
return to operating
temperature
before
using.
The Frequencer
®
V2x should not be used when the
humidity
exceeds
93% (non-condensing) or goes below 1 5
% .
If the device becomes
damp,
wait
until
it
dries completely before using
it.
WARNING: The Frequencer
®
V2x should not be stacked with other
equipment. If such placement becomes necessary, the Frequence
®
V2x
should be closely observed to ensure normal operation.
WARNING: The
ventilation
openings should never be
obstructed.
[6] Preparing for
treatment
Before using the Frequencer
®
V2x for the first time, please ensure
the
device has been cleaned as indicated in section
8.
S
TEP
1
:
Ensure you have all the components (see section 4_A).
STEP 2: Connect the power supply to the control
unit.
STEP 3: Plug the electrical cable into the power
supply.
STEP 4: Plug the electrical cable into a proper AC electrical
ou
tlet.
WARNING: INSPECT THE POWER CORD OFTEN FOR ANY SIGNS OF
DAMAGE. REPLACE A DAMAGED CORD
IMMEDIATELY.
WARNING: DO NOT PLACE THE
FREQUENCER
®
CONTROL
UNIT
IN A
POSITION THAT MAKES IT DIFFICULT TO
DISCONNECT
FROM THE MAIN
POWER SUPPLY.
104° F
(40° C)
41° F
(5° C)
93%
15%
To Next Page
Loading...