Follow these steps to install your LabelPoint 350 label printer and print your first label.
1. Unpacking your Printer
NOTE If you are connecting the printer to a Windows system, do not plug the printer into your computer until
asked to do so during the software installation.
1 Unpack your label printer and save the packing materials.
2 Make sure you have all the items shown in Figure 1.
2. Connecting the power
The label printer can operate on AC or battery power.
To insert the batteries
1 Remove the battery compartment cover. See Figure 2.
2 Insert the batteries following the polarity markings (+ and –).
3 Replace the battery compartment cover.
To connect the power adapter
1 Plug the power adapter into the power connector on the top, left side of the printer.
2 Plug the other end of the power adapter into a power outlet.
Symbols
Language
Preview
Insert
1, 2..N
Figure 1
Warranty booklet
LabelPoint 350 labelmaker
CD-ROM
D1 label cassette
Quick Start Guide
USB cable
User Guide
Figure 2
Quick Start
To Next Page
