Contents [ hide
1 INSTALLATION & OPERATING INSTRUCTIONS
2 FCC COMPLIANCE
3 USER MAINTENANCE INSTRUCTIONS –
CLEANING
4 HOW THE DYNATRAP® INSECT TRAP WORKS
5 TROUBLESHOOTING
6 LIMITED WARRANTY
7 REPLACEMENT PARTS
8 File Downloads
9 References
10 Related Manuals
INSTALLATION & OPERATING INSTRUCTIONS
1. Unpack unit. Save carton for off-season storage (if needed).
2. If hanging the unit, place approximately 3-6 feet above the floor/ground level for optimal catch rate and easy
access for cleaning. Unit can also be placed on the floor or ground.
3. Plug cord into an outdoor outlet or extension cord as described in “IMPORTANT SAFETY INSTRUCTIONS”.
4. Turn power switch to “ON” position. The switch is located under the upper housing on the outer rim.
5. For best catch results leave unit on at all times, except when cleaning or servicing.
6. Catch rate activity will be higher at night. For best catch results it is recommended to keep the unit away from
competing light sources.
7. It is recommended to place the unit at least 20 to 40 feet away from your outdoor living area. 8
8. This unit is all-weather resistant – designed for outdoor use including rainy conditions. Intended for household
use only.
9. To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This
plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
10. SERVICING OF DOUBLE-INSULATED APPLIANCES – In a double-insulated appliance, two systems of
insulation are provided instead of grounding. No grounding means is provided on a double-insulated appliance,
nor should a means for grounding be added to the appliance. Servicing of a double-insulated appliance requires
extreme care and knowledge of the system and should be done only by qualified service personnel.
Replacement parts for a doubleinsulated appliance must be identical to those parts in the appliance. The
symbol must be identical to those parts in the appliance. A double-insulated appliance is marked with the words
“DOUBLE INSULATION”, “DOUBLE-INSULATED” or the symbol:
FCC COMPLIANCE
This device complies with part 18 of the FCC rules. This product may cause interference to radio equipment and
should not be installed near maritime safety communications equipment or other critical navigation or communication
equipment operating between 0.45-30 MHz. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
USER MAINTENANCE INSTRUCTIONS – CLEANING
Frequent cleaning will prolong the life of the unit, ensure fire prevention and provide for more efficient operation.
To Next Page
Loading...