10
4. Steering Column Assembly
. Turn the vehicle body on its side as shown in picture below.
. Slide a 10 washer onto the steering column from the straight end.
. Insert the straight end of steering column up through the bottom hole at the front of vehicle
body, and out through the hole in the dash.
. Insert the bent end of steering column through the hole in the front axle linkage.
. Fit a 10 washer onto the bent end of the steering column.
. Insert a split pin into the hole in the bent end of steering column, and split it using standard
slip joint pliers (to assure the washer will not fall out).
5. Steering Wheel Assembly
. Put the vehicle body upright.
. Remove the M5x45 machine screw and M5 nut from
the steering wheel with a screwdriver.
. Insert the steering wheel onto the end of the steering
column, line up the hole in the steering wheel and the
hole in steering column, reinsert the M5x45 machine
screw and M5 nut as shown and tighten the
connection with a screwdriver.
(Make sure to align their holes, then tighten securely.)
6. Windshield Assembly
. Fit the tabs on the windshield into slots located at
front of the vehicle as shown, push until you hear it
click into place.
slot and ensure that the orientation of the windshield
is correct. Once the tab clicks into place, it cannot be
pulled out without damaging the vehicle.
Gently insert each tab into the correspondingNote:
7. Power Supply Connection
Note: The battery is disconnected for shipment to
prevent the battery from draining.
. Make sure to plug A connector into B connector.
(They are the same color to assure correct
connection.)
. Make sure to plug C connector into D connector.
(They are the same color to assure correct
connection.)
Ø
Ø
M
To Next Page
Loading...
Need help?
General
