Dynam Supermate DC6 - User Manual

Covers cell balancing, support for Lilo/LiPo/LiFe, and special 'Fast'/'Storage' modes.

Includes delta-peak sensitivity, auto-charge limit, and capacity limit for safe operation.

Covers supervision, environmental conditions, power input, and setup surface requirements.

Details voltage levels, charge rates, and discharge cut-off for NiCd/NiMH, LiPo, LiFe, and Pb batteries.

Instructions on connecting leads, avoiding short-circuits, and handling different battery types.

Emphasizes checking battery type, current, connections, and pack composition before charging.

Guides on connecting leads, using correct current, and handling Lithium battery pack composition.

Advises on setting discharge voltage, avoiding deep discharge, and handling memory effect in NiCd/NiMH batteries.

Setting nominal voltage and cell count verification time for Lithium batteries.

Step-by-step guide for setting current and voltage for standard Lithium battery charging.

Balances individual cell voltages during charging using the individual cell connector.

Sets discharge current and final voltage, adhering to manufacturer recommendations.

Monitors and normalizes cell voltages during discharge or storage mode for pack health.

Explains error messages like 'CELL LOW VOL' and how to identify bad cells or connections.