Need help?Do you have a question about the Dynamac DB 26 and is the answer not in the manual?
Secures the safety guard (A) to the shaft arm with screws for safe operation.
Attaches the cutting disk to the machine, excluding bent drive shaft models.
Installs the nylon line head onto the shaft arm.
Use a 4% (25:1) oil/gasoline mixture for the engine.
Engine reaches max power after 5-8 hours; avoid high throttle without load.
Guide to cleaning the air filter and adjusting the idle screw.
Proper harness adjustment ensures balance and correct height.
Keep hands on handles, check blade for damage after impacts.
Clean filter every 8-10 hours to ensure optimal engine performance.
Periodically check fuel filter; replace if dirty for easier starting.
Clean cylinder fins to prevent overheating and engine damage.
Clean and check spark plug gap periodically for optimal ignition.
Check grease level in gear housing every 30 hours.
Instructions on how to sharpen and balance cutting blades.
To Next Page
General