PROGRAMMABLE OPTIONS cont’
TURNS DESCRIPTION 1 FLASH RESPONSE 3 FLASHES RESPONSE
5 Siren chirp order Reversed Standard
7 Immobilisation dropout time* When armed After 30 seconds
9 Arm/disarm flash confirmation** Enabled Disabled
11 Siren/horn output type Pulsed for 30 sec Constant for 30 sec
13 Arm/disarm confirmation Disabled Enabled
15 Voltage drop sensing* Disabled Enabled
17 Door sensing delay 5 seconds 30 seconds
19 Change PIN Code - refer to page 7
* Changing these options may drain vehicle battery or reduce alarm effectiveness -
installer option only.
** Disabling option #9 means diagnostics is only visible
through status LED.
The P485 is overridden in two parts; a high security
lock/switch mounted on the back of the siren and by a
four digit PIN entered through the ignition switch.
Locate the siren under the bonnet.
Remove the protective black plastic dust cap and
insert the key into the lock. Turn 90 degrees to over-
ride the P485.
This will instantly stop the siren sounding. The P485 is
still armed. The next step shows how to disarm the
P485.
OVERRIDE
Security Switch
!
!
- Page 6 -
To Next Page
Loading...