DIAGNOSTICS
PROBLEM SOLVING
For your convenience and peace of mind the P485 features a user friendly diagnostic
facility, that reports the source of the last trigger. The report is produced by disarming
the P485 during or after a siren trigger. The report consists of the normal indicator
disarm flash, followed by 1, 2, 3 or 4 flashes. Each number of flashes denotes a
different trigger source. See the table below for number definitions.
1 Bonnet
2 Millivolt Sensing
3 Doors
4 Glass Breakage
NB: The diagnostic is best viewed through the status LED as the vehicle may also flash
indicators when unlocking. The reporting feature is disabled if the installer has disabled
arm/disarm confirmation indicator flash (see programmable option #9, page 6).
System won't trigger
Ensure that you have allowed at least 40 seconds after arming, before testing.
If testing boot, ensure boot light comes on only when boot switch is operated; it must
not remain on constantly.
Should the problem you are experiencing persist, consult your Cyclops dealer.
The remote control fails to operate
Try your spare remote control as supplied by the vehicle manufacturer.
Contact the dealer from which the vehicle was purchased or vehicle manufacturer
helpline.
FLASHES TRIGGER SOURCE
!
!
!
!
!
- Page 8 -
To Next Page
Loading...