Dynamic DX Power Module PMB - Page 12

';3RZHU0RGXOH)HDWXUHV
7
3URJUDPPDEOH&KDUDFWHULVWLFV
The PM has the following programmable characteristics :
 Maximum motor current;
 Motor resistance (load compensation). Compensates for drive motor
inefficiencies. Correct compensation provides an even drive characteristic
over irregular driving conditions and terrain (eg on the flat, up hills, etc.);
 Wheelchair veer compensation (for motor mismatch compensation);
 Park Brake delay between the wheelchair stopping and the Park Brake
engaging;
 Park Brake configuration (single or dual);
 Motor stall time out duration and enable (on or off);
 Rate of deceleration under fault conditions;
 Left/Right Motor swap option to facilitate motor looming;
 Left/Right Motor connector polarity swap to accommodate motor connector
polarity options;
 Optional thermal motor protection;