Dynamic DX Power Module PMB

To Next Page

To Previous Page

,QVWDOODWLRQ

30&RQQHFWLRQZLWK0RWRUVDQG3DUN%UDNHV

0RWRUDQG3DUN%UDNH&RQQHFWRU3LQ'HILQLWLRQV

The Left Motor and Park Brake connector and the Right Motor and Park Brake

connector are identical.

Note : The motor connections shown above are correct for Power Modules

which have their programable Left/Right Motor Swap parameter set to ‘NORM’.

If set to ‘SWAP’, the Left and Right motor connectors will be swapped from that

shown. For this reason, the connectors are not labelled Left and Right, but M1 and

M2, as shown.

The polarity of the motors connectors shown is correct for Power Modules which

have their programmable Motor Invert parameter set to ‘No’. If set to ‘Yes’, the

polarity of the + and - terminals will be opposite. In either case, the + terminal will

increase in voltage in response to a joystick being pushed forward.

See Page 23 for PM-S connector pin definitions.

Dynamic DX Power Module PMB - Page 26