Dynamic DX Power Module PMB - Page 57

 3URJUDPPLQJ
52
2. Then the main menu screen reads :
* * MAIN MENU * *
View or edit?
Program : 1 ?
NEXT YES
Pressing NEXT cycles through the Drive Programs. Refer to the DX Remote
Installation Manual for details of how to view and adjust Drive Programs.
7R(QDEOH7HFKQLFLDQ0RGH
1. Press ’NEXT’ until the Technician Mode screen appears :
* * MAIN MENU * *
Technician Mode
disabled. Enable ?
NEXT YES
Pressing ‘YES’ toggles this screen between Technician Mode Enabled and
Technician Mode Disabled. If disabled, press ‘YES’ to enable.
2. Press 'YES’ and a password screen will appear. Enter the three digit password.
Technician Mode
Enter Password
0 0 0
EXIT D1 D2 D3
Press the D1, D2 and D3 buttons to cycle each digit through to the correct
password. When the password reads correctly, press the 'EXIT' button.
The screen now reads :
* * MAIN MENU * *
Technician Mode
enabled. Disable ?
NEXT YES