31
know that the heat emitters are working successfully. With even one heat
emitter not working correctly, the sauna room will struggle to get above
130 degrees F within the average allotted time. The next test would be to
enter the sauna room and to cautiously place your hand on the back side
of the bench heat emitter in the center (this would normally be covered by
the bench which you
already removed). If you touch the heat emitter panel and it is warm-to-
hot, then it is working correctly. If you are able to place your hand on the
back side of the heat emitter and it feels like there is no heat being
produced, then we know it is not working properly and you will need to
contact Customer Service. You can also check the floor heat emitter by
touching the heat emitter cautiously with your finger. You will need to
remove the wood grade cover to get a true feeling of the heat from the
floor heat emitter. Please do keep in mind that the bench heat emitter and
floor heat emitter only keep the area below the bench warm as heat
always rises. The majority of heat is concentrated above the bench. You
can use a towel to drape over your legs to trap the heat as it rises if your
lower extremities feel a draft.
11. Intentional Rear Wall Warp
Solution: The rear wall panel is intentionally warped as part of the sauna
design. This adds strength to the sauna structure once the unit is
assembled. Please try the following in assembling the sauna. With one
person inside the sauna room and pushing on the rear wall panel outward,
a second person should be able to latch the buckles. Make sure that the
wall is fitting together like a puzzle as one wall panel fits into the other.
Work your way down from top to bottom.
12. Too Much Perspiration On The Floor Heater
Solution: Use 2 towels during your sauna session. Fold the first towel
several times and place it on the bench. As you sit on this towel, it will
absorb a majority of your perspiration while adding comfort as you sit on
the bench. Use the second towel to constantly wipe the perspiration from
your body to perspire faster and also to avoid having too much
perspiration dripping onto the floor heater. Never place any towels over
the floor heater.
To Next Page
Loading...