WARNING
ADDITIONAL LEG HEIGHT
ASSEMBLY INSTRUCTIONS
AND PRECAUTIONS
1. Before use, adjust height of each leg to your specific needs,
making sure all legs are at the same height. When desired
height is reached, lock legs into place by aligning buttons
into
proper holes (see Figure 1).
2. Be sure legs are locked into place by pushing down on
or by
pulling legs.
1. Unfold the sides of the commode frame and stand upright.
2. Attach front cross brace by depressing brass push pins and
sliding brace into side frame socket. Repeat on the other
side. Be sure brass push pins “snap” through holes.
3. Attach back brace by depressing brass push pins and
sliding back brace into receptacle located on back of cross
brace. Be sure brass push pins “snap” through holes.
4. Lower commode bucket or splash guard into bracket.
5. Attach seat and lid onto back of frame.
1. DO NOT use commode without first reading and
understanding this assembly and instruction sheet. If you
can not understand these instructions, contact a healthcare
dealer or technical professional before attempting to install.
Otherwise, injury or damage may occur.
2. Make certain that the height adjusting snap buttons fully
protrude through the respective hole.
3. Ensure that all components of the commode are secure
and locked in place.
4. Check the rubber tips on the legs for rips, wear or if they
are missing. Immediately replace any or all if any
imperfections exist.
5. All four leg extensions with rubber tips MUST be level to
the floor.
6. Users with limited physical strength should be supervised
or assisted while using commode.
Push Pins
Side
Frame
Side
Frame
Socket
Front Cross
Brace
Commode
Lid
Commode
Bucket
Back
Brace
FIGURE 1
To Previous Page
Loading...
Need help?
General
