Need help?Do you have a question about the Dynasty Spas 2008 and is the answer not in the manual?
Specifies requirements for spa placement surfaces and pads, recommending a concrete pad.
Outlines structural requirements for spa installation on balconies and decks, adhering to codes.
Explains the electrical needs for spa operation, including voltage and GFCI breaker types.
Specifies the type and gauge of copper wire needed for spa installation and bonding.
Illustrates correct wiring procedures for the GFCI load center and neutral connection.
Provides step-by-step instructions for priming the spa pump to ensure water circulation.
Step-by-step guide for cleaning and replacing the spa filter cartridge for optimal performance.
Maintenance procedures for enclosed filter systems, including filter door and cartridge removal.
Explains the three-step process for maintaining clean and sanitary spa water: Balance, Filtration, Sanitation.
Troubleshooting steps for issues related to low or no spa heating, like dirty filters or breaker issues.
Solutions for when the spa pump fails to prime, checking water level, valves, and connections.
Diagnosing and fixing common causes of spa leaks, such as loose connections and fittings.
Troubleshooting steps when the spa motor fails to start, checking power, plugs, and potential jamming.
Addressing issues where the spa motor experiences overheating, suggesting reprogramming or ventilation checks.
General| Year | 2008 |
|---|---|
| Category | Hot Tub |
| Voltage | 240V |
| Shell Material | Acrylic |
| Insulation | Full Foam |
| Heater | 4 kW |
To Next Page