INSTRUCTIONS: REPLACEMENT/SAFETY GEAR; Code: DYN 32.03.00
Date: 29/06/2016 Revision: 00
9
Figure7 Removing the shoe
7. Explanatory video link (registered customers only):
http://customers.dynatech-elevation.com/download.php?file=imagenes/documentos/doc-00597.mp4
2.3 PR-2000 UD
There are two PR-2000 UD safety gear types, depending on the thickness of the shoe assembled. The
safety gear types refer to the guide rail centre position in relation to the frame attachment holes, which are in
accordance with the measurement recommended in the safety gear usage and maintenance instructions.
Thus, the gap between the shoe and guide rail established by Dynatech is observed.
TYPE A B
THICKNESS (mm) 5-6-7-8-9-10 11-12-13-14-15-16
The steps for replacing the shoe to change the thickness are as follows:
1. The following must be available:
- Replacement shoe: with the new guide rail thickness.
To Next Page
Loading...