Need help?Do you have a question about the Dynatronix LT1200X SERIES and is the answer not in the manual?
General| Output Current | 0-12 A |
|---|---|
| Cooling | Forced air cooling |
| Output Voltage | 0-120 VDC |
| Power | 1200 W |
| Temperature Coefficient | 0.02%/°C |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 85°C |
| Dimensions | 19" |
Details warranty terms, conditions, and exclusions for new products.
Explains the function of each control and indicator on the LT power supply's front panel.
Contains features and parameters adjustable for specific processes.
For infrequent configuration changes like password, host port, and system settings.
Sets up the host port's baud rate and unit ID for communication.
Sets the source for current and voltage settings when in remote mode.
Explains Real Time Control (RTC) and Amp Time Control (ATC) modes for timed cycles.
Configures percentage-based tolerances for current and voltage readings to report errors.
Describes how to view and manually clear active error codes from the unit.
Details how to adjust the voltage setting using the voltage encoder.
Details how to adjust the current setting using the current encoder.
Explains how to set the unit for current regulation mode.
Explains how to set the unit for voltage regulation mode.
How to set current regulation with an upper voltage limit.
How to set voltage regulation with an upper current limit.
Covers unit ID and baud rate settings for host communication.
How to control voltage and current settings using analog inputs to the option card.
General information on calibration, performed via front panel interface.
Describes necessary calibration equipment like meters and shunts.
Provides a summary of the calibration steps and menu selections.
Sets calibration values for current output and its read-back meter.
Sets calibration values for voltage output and its read-back meter.
Procedure for calibrating the optional analog control interface.
Diagram of the Unit Setup Menu, leading to Cycle, Tolerance, and Error Handling.
Diagram for configuring cycle control types, units, and target times.
Diagram for setting current and voltage tolerance limits.
Diagram for managing error message display and clearing error codes.
Diagram of the main configuration menu for totalizer, host, system, and calibration.
Diagram for setting host port baud rate and unit ID.
Diagram for calibrating front panel meters and output.
To Next Page