Troubleshooting
9
3 Double-click Network adapters to display the list of
network adapters. You see Dynex Gigabit PCI Adapter.
You should see a yellow exclamation point or red "X" over
the icon adjacent to Dynex Gigabit PCI Adapter, your
adapter is not installed correctly or may have a problem.
Double-click Dynex Gigabit PCI Adapter to read the
explanation of the problem. This information will be
helpful if you need to contact a Dynex technical support.
Verify cable connections
To verify cable connections:
1 Make sure that the computer(s) you are troubleshooting
are connected correctly.
2 Each network adapter must be connected to the network
with Category 5 UTP (unshielded twisted pair) cables.
3 Examine the network cables and make sure that they have
not been damaged.
4 Make sure that no electromagnetic interference, like
unshielded speakers or appliances on the same circuit, is
affecting your network.
5 If you are using a hub, router, or switch, make sure that
your network cables are not plugged into a dedicated
Uplink port. The Uplink port is only used when connecting
your hub to another hub or switch.
DX-PCIGB English.fm Page 9 Thursday, September 24, 2009 9:07 AM
To Next Page
Loading...