3
COMMISSIONING
QQ
QQ
Q
UICKUICK
UICKUICK
UICK
SS
SS
S
TT
TT
T
ARAR
ARAR
AR
TT
TT
T
UTILIZINGUTILIZING
UTILIZINGUTILIZING
UTILIZING
H H
H H
H
ARAR
ARAR
AR
TT
TT
T
C C
C C
C
OMMUNICAOMMUNICA
OMMUNICAOMMUNICA
OMMUNICA
TT
TT
T
OROR
OROR
OR
1. Follow Steps 1 through 3 from Quick Start Using Push-Buttons.
2. Connect Communicator to the loop. If unsure on how to do this, refer to “Connecting the Hart
Handheld Communicator” (Fig. 6-1).
3. Power on Hart Communicator. See Hart Command tree on the following page for reference.
From the Main Menu:
4. Enter Tag (Quick Key 1,3,1)
5. Set Pressure Units (Quick Key 1,3,2), if required
6. Set URV (Quick Key 1,3,3,2) if output turndown (rescaling), is required.
7. Perform Zero Trim (Quick Key 1,2,5,4,1)
8. Verify loop output is zero (4mA).
9. Remove Hart Communicator from loop.
To Next Page
Loading...