4 POD-300 INSTALLATION GUIDE
IPOD-300
PCV/6 FUEL TRIMS
This menu allows you to adjust the PCV/6 fuel trims for the low, mid, and high RPM ranges.
1 From the Main Menu, select Device Setup>PCV/6 Fuel Trims.
2 Select Low to adjust the fi rst third of your RPM range. Use the +/- symbols to increase/decrease the fuel of
this range.
3 Select Mid to adjust the second third of your RPM range. Use the +/- symbols to increase/decrease the fuel
of this range.
4 Select High to adjust the last third of your RPM range. Use the +/- symbols to increase/decrease the fuel of
this range.
Example: If your engine’s RPM range is 12000rpm LOW+0-4000, MID=4001-8000, and HIGH=8001-12000.
Note: These ranges can be adjusted in Control Center Software of Power Core Software if desired.
WB2 LAMBDA SETUP
This menu allows you to setup the WB2 lambda settings.
1 From the Main Menu, select Device Setup>WB2 Lambda Setup.
2 Select Stoich Value to set predetermined stoichiometric values for different fuels.
3 Select Lambda Smoothing to smooth, or average, the AFR and Lambda channels. Lower values will result
in the highest resolution, minimal latency, and would be preferred in situations where you are datalogging.
4 Select Lambda Out Threshold. .9-1.1, default value = 1 - Sets up the Narrowband O2 Out function on the
Wideband 2 (green wire). Changing this value will change the AFR that WB2 switches the narrowband
signal around. For example, if using a value of .95, the WB2 will emulate a narrowband voltage signal that
switches to rich if the Lambda reading is lower than .95, and lean if the Lambda reading is higher than .95.
To Next Page
Loading...