Power and remote control*Tilt function
Remote control docks magnetically
Attach remote control to top of heater
with the buttons facing down.
*Remote control with selected models only.
To operate, point remote control toward the front of the base.
Carefully hold the base and the top of the air loop amplifier.
Tilt forward or backward for the required airflow angle.
To change the airflow speed press the airflow speed
control button. The digital display will show the new
speed; after 3 seconds it will change back to the
target temperature.
To start the heater oscillating, press the oscillation
control button. To stop the heater oscillating, press it
again. The heater will not oscillate when the control
buttons are pressed.
Stand by
on/off
Airflow
speed control
Oscillation
on/off
Thermostat
control
3. Airflow speed control 4. Oscillation control
To Next Page
Loading...
Need help?
General
