4 5 6
Plug into the socket and base. A small
blue LED on the back of the appliance
lights up to confirm that the appliance
has power.
Switch ‘ON’. The water treatment
procedure automatically starts.
Water passes over a UV-C emitter to
ensure that it is 99.9% bacteria-free
before misting commences. This takes
approximately 3 minutes. (During this
time humidity targets can be set and
fan mode can be switched ON’.)
After 3 minutes the appliance will start
to humidify. The display will show the
target humidity setting.
77
To Next Page
Loading...
