Dyson AM10 - Refilling the Tank

Humidity percentage
When animation sequence shows, the tank is empty.
Unplug the appliance and push the button to unlock.
Lift the loop amplifier away from tank, then tank away
from base.
1
3
2
Switch ‘ON’: the water treatment procedure
starts. After 3 minutes the appliance will start
to humidify.
Remove the cap and fill tank (no other part) to the top
with cold tap water. Replace the cap, tank and loop
amplifier. Use the handle for easier handling.
%
A
Automatic Mode
On/off
Press and hold the power
button on the appliance to
adjust the humidity setting.
Blue light indicates that the
AM10 is in humidity mode.
White light indicates that
the AM10 is in fan mode.
9
Refilling the tank