Washing your filter
Wash your filter
Fill and shake
Tap your filter
Twist off your filter
For more information and support videos for your machine go
online: www.dyson.com/support
Wash with warm, running tap water – gently rubbing your filter with your
fingers to remove the dirt.
Before washing your filter, tap it gently over a bin to remove any loose dust
and debris.
Twist your filter anti-clockwise and pull it away from your machine.
Wash your filter at least once a month to maintain optimum suction power.
The filter LED will illuminate on the top of your battery when the filter
needs cleaning. This LED will flash if the filter isn't fitted correctly.
Fill the filter with warm tap water.
Place your hand over the open end of the filter and shake it firmly to remove
trapped dirt and debris.
Repeat these steps until the water runs clear.
Shake and dry
Empty the filter and shake firmly to remove excess water.
Keep shaking until there’s no water coming from the filter.
Place your filter end up, as shown.
Place the filter on its end and leave to dry for at least 24 hours in a well
ventilated, warm place.
Don’t dry your filter in a tumble dryer, microwave or near a naked flame.
Important: your filter must be completely dry before you put it back into the
machine. Your machine could be damaged if used with a damp filter.
To Next Page
Loading...
