EasyManua.ls Logo

Dyson DC 35 - Filter Maintenance and Blockages; Charging, Storing, and Battery Safety

Dyson DC 35
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ensure the clear bin is completely dry before replacing.
WASHING YOUR FILTER
CAUTION:
Switch ‘OFF’ and disconnect from charger before removing the filter.
Wash the filter with cold water only.
Ensure filter is completely dry before refitting to the Dyson vacuum cleaner.
PLEASE NOTE:
This Dyson vacuum cleaner has one filter, located as shown. It is important to check your filter and wash with
cold water regularly or as required, to maintain performance. Please leave to dry completely for 12 hours.
The filter may require more frequent washing if vacuuming fine dust or used mainly in ‘HIGH CONSTANT
SUCTION’ power mode.
Do not use detergents to clean the filter.
Do not put the filter in the dishwasher, washing machine, tumble dryer, oven, microwave or near an open flame.
LOOKING FOR BLOCKAGES
CAUTION:
Switch ‘OFF’ the Dyson vacuum cleaner and disconnect from charger before looking for blockages. Failure to
do so could result in
personal injury.
Beware of sharp objects when clearing blockages.
Refit all parts of the Dyson vacuum cleaner securely before using.
PLEASE NOTE:
Clearing blockages is not covered by the Dyson vacuum cleaner’s guarantee. If any part of the Dyson vacuum
cleaner becomes blocked, it may overheat and then automatically shut off.
Switch ‘OFF’ and unplug your Dyson vacuum cleaner and leave to cool down. Clear blockage before restarting.
CLEARING BRUSH BAR OBSTRUCTIONS
CAUTION:
Switch ‘OFF’ the Dyson vacuum cleaner and disconnect from charger before clearing brush bar obstructions.
Failure to do so could result in personal injury. If your brush bar is obstructed, it may turn off. If this happens you
will need to remove brush bar as shown and clear any obstructing debris.
Remove the brush bar by using a coin to turn the fastener marked with a padlock until it clicks. Remove the
obstruction. Replace the brush bar and secure it by tightening the fastener until it clicks. Ensure it is fixed firmly
before operating.
Take care if coming into contact with the carbon fibre brushes, as they may cause minor skin irritation. Wash
your hands after handling the brushes.
Beware of sharp objects when clearing blockages.
Refit all parts of the Dyson vacuum cleaner securely before using.
CHARGING AND STORING YOUR DYSON VACUUM CLEANER
Your Dyson vacuum cleaner will turn off if the battery temperature is below 3°C. This is designed to protect the
motor and battery of your product. Do not charge the Dyson vacuum cleaner and then move it to an area with a
temperature below 3°C for storage purposes.
To help prolong battery life, avoid recharging immediately after a full discharge. Allow to cool for a few minutes.
Avoid using the Dyson vacuum cleaner with the battery flush to a surface. This will help it run cooler and prolong
battery run time and life.
If mounting the charging dock on a wall, follow the instructions supplied with this Dyson vacuum cleaner.
Ensure the dock is fitted correctly and the right way up, so the motor of the Dyson vacuum cleaner is at the top
when in place. Take all necessary safety precautions. Use appropriate fixings, tools and safety equipment.
BATTERY SAFETY INSTRUCTIONS
Use only Dyson batteries and charging unit for the Dyson vacuum cleaner.
The battery is a sealed unit and under normal circumstances poses no safety concerns. In the unlikely event

Other manuals for Dyson DC 35

Related product manuals