3 Using your DC15
(continued)
Brush control
To turn the brushbar OFF for
bare or delicate flooring, rugs,
and carpets, put the machine in
the cleaning position, and press
the red button. Press it again to
restart brushbar.
tip Ensure the stabilizer clicks into
place before vacuuming.
Small movements of the wrist will create a zigzag motion in the cleaner
head for easier cleaning around furniture.
tip Twist and turn your wrist like you are turning a doorknob to make the
most of DC15’s maneuverability.
When finished, push the
handle firmly beyond the
upright position to drop the
stabilizing wheels.
Ensure stabilizer
wheels are fully locked
in place before releasing
the machine.
IMPORTANT
• The brushbar will reset to
“ON” each time you start
the machine and put it in
the cleaning position.
• If the brushbar stops
during use, please refer
to the clearing blockages
section.
• Ensure stabilizer wheels
are fully locked in place
before releasing the
machine.
• Consult your flooring
manufacturer’s
recommended instructions
before vacuuming your
flooring, rugs, and carpets.
Some carpets will fuzz if
a rotating brushbar is
used when vacuuming.
If this happens we
recommend vacuuming
in bare floors mode and
consulting with your
flooring manufacturer.
To Next Page
Loading...
Need help?
General
