service manual
Issued 10/06
7
Fitting notes
If necessary remove the standard post filter
assembly from the standard post filter cage
(non HEPA models only).
8
Press the cyclone release catch and remove
the cyclone assembly and bin assembly from the
front of the duct assembly. If necessary the pre-
filter can be removed/checked from inside the
top of the cyclone assembly.
5
Pull the lower cable winder off the rear of
the duct assembly.
4
If necessary remove the HEPA post filter
assembly from the post filter cover.
7
Undo and remove the two cheesehead screws
in the lower cable winder.
3
Twist the post filter cover to remove the post filter
cover and post filter from the motor retainer ring.
6
To Next Page
Loading...
