service manual
Issued 10/06
28
Fitting notes
Slide the PCB assembly into the ribs in the
brushbar motor cover.
121
Dress the PCB wire and cleaner head
connector block wire neatly/securely into the
retaining clips provided.
122
Refit the TCO reset switch. Attach the two
wires to the TCO reset switch. Dress all wires
neatly into the retaining clips provided.
123
Position the front of the brushbar motor into
the front motor mount.
126
Attach the red wire to the motor terminal.
125
Slide the front motor mount into the front of
the brush housing.
124
To Next Page
Loading...
