service manual
Issued 10/06
Firmly pull the wheel, washer and axle out
of the undercarriage.
Refit in reverse.
If the gimble lock pin assembly needs
replacing, undo the screw in the front of the
undercarriage.
Lift the gimble lock cover and spring out of
the undercarriage. Remove the gimble lock pin.
33
Fitting notes
To replace the rear wheels simply undo the
circlip on the rear of the wheel.
After refitting a micro switch cam assembly, it
is advisable to check for actuation.
152
154
149
151
Slide the micro switch housing into the
undercarriage.
150
153
To Next Page
Loading...
