Do not push hard with the floor tool when vacuuming, as this may cause damage.
Do not leave the cleaner head in one place on delicate floors.
On waxed floors, the movement of the cleaner head may create an uneven luster. If this happens, wipe with a
damp cloth, polish the area with wax, and wait for it to dry.
To reduce suction (for example, when vacuuming rugs), pull the suction release trigger on the handle to reduce
the airflow.
EMPTYING THE CLEAR BIN
Empty as soon as the dirt reaches the level of the MAX mark – do not overfill.
Switch ‘OFF’ and unplug before emptying the clear bin.
To remove the cyclone and clear the bin unit, push the release button to the side of the carrying handle, as
shown. The carrying handle will be released.
To release the dirt, press the red bin release button.
To minimize dust/allergen contact when emptying, encase the clear bin tightly in a plastic bag and empty it.
Remove the clear bin carefully from the bag.
Seal the bag tightly, dispose of as normal.
Close the clear bin base so it clicks into place and is secure.
Place the clear bin and cyclone unit into position on the front of the main body of the appliance. The recess in
the base of the clear bin must fit onto the lug on the support bracket.
Push the carrying handle down so it clicks into place on the top of the clear bin and cyclone unit. Ensure it is
secure.
CLEANING THE CLEAR BIN
Remove cyclone and clear bin (see ‘Emptying the clear bin’).
To separate the cyclone from the clear bin press the red bin release button to open the bin base. This exposes a
small silver button behind the red opening mechanism.
Press the small silver button on the cyclone. Separate the cyclone from the clear bin.
Clean the clear bin with cold water only.
Do not use detergents, polishes or air fresheners to clean the clear bin.
Do not put the clear bin in a dishwasher.
Do not immerse the whole cyclone in water or pour water into the cyclones.
Clean the cyclone shroud with a cloth or dry brush to remove lint and dust.
Ensure the clear bin is completely dry before replacing.
To replace, first close the clear bin base so it clicks into place and is secure.
Fit the clear bin onto the cyclone. To secure it, first fit the slot on the front rim of the clear bin onto the lug on the
front of the cyclone; then push the rear of the clear bin into place so the silver button engages and clicks into
place.
Fit the cyclone and clear bin unit onto the appliance (see ‘Emptying the clear bin’).
WASHING YOUR FILTER
Your appliance has one washable filter, located as shown.
Check and wash the filter regularly according to instructions to maintain performance.
Switch ‘OFF’ and unplug before checking or removing the filter.
The filter may require more frequent washing if vacuuming fine dust.
Wash the filter with cold water only. Hold under a tap and run water through the open end until the water runs
clear. Turn upside down and tap out.
Squeeze and twist with both hands to make sure the excess water is removed.
Run water over the outside of the filter for 15 seconds.
Squeeze and twist with both hands to make sure the excess water is removed.
Place the filter on its side to dry completely.
Do not put the filter in a dishwasher, washing machine, tumble dryer, oven, microwave, or near a naked flame.
IMPORTANT: After washing please leave at least 24 hours to dry completely before refitting. BLOCKAGES –
THERMAL CUT-OUT
This appliance is fitted with an automatically resetting thermal cut-out.
If any part becomes blocked the appliance may overheat and automatically cut out.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
