6
Press the blue fan mode button to enter fan mode. The
power button light will change from red to blue to indicate
that you have entered fan mode. To adjust the airflow
speed use the airflow control button or use auto mode for
automatic control.
Each time the heating mode is selected, it conducts a short calibration cycle. Airflow will be automatically controlled during this cycle.
Once the calibration cycle is complete, it will revert to the selected airflow speed.
Press the red thermostat control button until the digital display shows the target room temperature. The power button light will change
from blue to red to indicate that you have entered heating mode. The heating symbol will be red while heating and will change to
white when the target room temperature has been reached. Once the target room temperature has been reached, the appliance will
stop heating the air. If the room temperature falls below the target temperature, the appliance will start to heat again. The red circle
surrounding the power button remains on when the product is in heater mode. To adjust the airflow speed use the airflow control button
or use auto mode for automatic control.
Room heating to 23°C Room heated to
23°C or above
Appliance is in fan mode
Appliance is in heating mode
Heating and fan modes
On first use, the appliance will default to a temperature 3°C
higher than the detected room temperature. Thereafter, the
appliance will remember the last target temperature set.
21.02.2017 15:52 - C84661_HP03_OPMAN_ANZ_ X455_84661.indd_15_4c0s
To Next Page
Loading...
Need help?
General
