1 2 3
4 5 6
7
6 sec
clik
clik
29
Replacing the filter unit
When your non-washable filter unit needs replacing
the appliance will display the pattern shown. To replace
the non-washable filter unit, follow these steps. Ensure
the appliance is unplugged, if the appliance has been
in use, leave for 1 to 2 hours before replacing the filter
unit to allow the appliance to cool down completely.
Your Dyson appliance is programmed to remind you to
replace the filter unit after 12 months based on 12 hours
usage a day. Please note your indicator will activate
sooner with more use. The indicator is only a guide and
you may need to replace the filter unit more regularly.
A clockwise-rotating
loading pattern will be
shown on the LED display.
Once the loading
pattern is complete, the
appliance will return to
its normal usage.
When you have re-assembled
your appliance, press and hold
the ‘Standby ON/OFF’ button for
6 seconds on the remote control
to reset the filter indicator.
When disposing of the exhausted filter
unit please do so in accordance with
local regulations.
To Next Page
Loading...
Need help?
General
