Diffused and Focused modes
Sleep timer
Oscillation and Airflow speed control
Tilt function
Focused mode
Press the narrow angle button to
change from a whole room airflow
to a personal directed airflow.
To set the sleep timer, select the desired time. When time
reaches zero, the machine will go into standby mode. To
cancel, increase the time until two dashes appear.
When using the sleep timer, the LED display will
turn off after 10 seconds of inactivity.
Airflow speed control
To change the airflow speed,
press the Airflow speed control
button. The digital display will
show the new fan speed. If in
heating mode, after 3 seconds
it will change back to displaying
the target temperature.
Oscillation control
To start the machine oscillating,
press the Oscillation control
button. To stop the machine
oscillating, press it again. The
machine will not oscillate when
the control buttons are pressed.
Diffused mode
Press the wide angle button
to change from a personal
directed airflow to a whole
room airflow.
Carefully hold the base and the main body. Tilt the loop amplifier
forward or backward for the required airflow angle.
Heating and cooling modes
work in this mode.
Heating and cooling modes
work in this mode.
To Next Page
Loading...
Need help?
General
