Loss of pick-up from the low profile contact head
Refit hose back into the inlet.
Separate the hose from the wand
handle° Switch machine ON and test
suction from the end of the hose. If
weak this indicates a blockage or
possible damage to the hose°
Reconnect the hose. Switch machine
OFF and separate the low profile
contact head from the telescopic
wand.
Ensure that both sections of the
telescopic wand are fully extended
and locked into place. Check length of
wand for damage° Check the suction
release button for damage. Switch
machine ON and test suction from the
end of the wand° If weak this indicates
a blockage or possible damage to the
wand handle. Switch machine OFF.
Bleed tab
Check low profile contact head for
blockages or damage° Check position
of the bleed tabs.
Reassemble the machine and switch
ONo If the machine operates as
normal end the callo If not arrange a
repair.
To Next Page
Loading...
