Dyson SV17

3-4.5hrs
clik
100%
2
1
3
clik
clik
7
Charging and storing
your machine
Connect to the charger either directly
or in the docking station.
The blue LEDs on either side of the
battery will flash during charging.
When the battery is fully charged,
both LEDs will light for 5 seconds.
Changing your battery
To remove a battery
Hold your hand under the
battery to support it.
Press the battery release
button and slide the battery
off the handle.
Place the battery on charge.
Where you have additional batteries, we
recommend that you alternate the batteries to
maintain even performance.
It's important to fully charge your new machine before
using it for the first time, and after every clean. This is
because the battery and monitoring system's algorithm
'learns' over time, and fully charging your machine
helps it to more accurately calculate and display
remaining run time.
To install a battery
Slide the battery onto
the handle until it clicks
securely in place.
Be careful not to pull the power trigger
while the clear bin is open for emptying.
Close the clear bin by pushing the bin base
upwards until the clear bin and bin base click
into place.
Your machine won’t operate or
charge if the ambient temperature is
below 5°C (41°F). This is designed to
protect both the motor and battery.
The recommended temperature
range for storage, operating and
charging your machine is between
18°C (64°F) and 28°C (82°F).
Emptying your clear bin
Your battery is fully charged when
the display shows 100%.