26
TROUBLESHOOTING
My Receiver / Transmitter is not tuming on
o
Make sure the collar receiver is fully charged Co lar receiver light
should turn green when the battery is connected to the charger.
My Receiver is not responding
O
Check Receiveds indicator light is blinking green and Transmitter LCD
is on. Check to make sure the collar receiveds indicator light is red
when the stimulation button is pressed.
o
Try pairing/ syncingthe transmitterto the receiver.(Page17)
"O
The receiver doesnt seem to provide stimulation to the dog
o
Remove Contact points from Receiver. Connect Test Light to the
receiver and test for stimulation. If the test light is blinking, receiver is
providing stimulation.
Max range of device has been decreased
o
Check Transmitters battery condition. Working range decreases
when the battery evel is low
Keep your fingers from touching the antenna. See the bottom of
page 8 for the proper technique to maximize range
You cannot change the stimulation level of the Transmitter
U
O
Make sure ID or 2D on transmitter LCD is blinking. f ID or 2D icons are
solid, you cannot change stimulation. You can unlock the stimulation
at any time by pressing the stimulation knob for 1 second
CONTACT US FOR EXPERT HELP WITH YOUR E-COLLAR
300/302 Owner's Manual
To Next Page
Loading...
