1. Crop out done as per template.
2. Arrow on spindle hub points down.
3. Check rubber gasket installed correctly with
lugs pressed in tight. So proper seal around
backplate edge is created.
4. Ensure split pin is installed, securing spindle
to the spindle hub.
5. Ensure screw casing bolts and through bolts tightened.
6. Ensure power cable wire installed correctly and not bent or
crimped in door.
7. Check batteries installed in correct position.
Professionally Installed by:
PIN-Code: Date:
_________________________
____________ ____/____/____
8 - S e r i e s
Summary Check List:
For further details see pages 8-12
Top
To Next Page
Loading...
