Need help?Do you have a question about the E-Service Nayax and is the answer not in the manual?
Central unit connecting Nayax components, place inside machine.
Locate control module, remove bill validator, replace software chip.
Flip switch to enable 10p coins, test software with various payment methods.
Place template, align, mark points, and drill holes for VPOS/Onyx mounting.
Insert grommet into drilled hole, screw VPOS/Onyx flush to machine front.
Attach AMIT 3 magnetically, connect VPOS/Onyx cable to AMIT 'VPOS' port.
General| Connectivity | WiFi |
|---|---|
| Payment Methods | Contactless Payments |
| Security | EMVCo Level 1 & 2 |
| Card Reader | EMV Chip, Magnetic Stripe |
| Printer | Optional external printer support |
To Next Page