Need help?Do you have a question about the E-TON sport 50 and is the answer not in the manual?
Provides essential safety precautions for operating and servicing the vehicle.
Details important precautions to follow during motorcycle service and maintenance.
Specifies torque settings for various engine components during assembly.
Specifies torque settings for various frame components during assembly.
Provides a schedule for routine inspections, cleaning, and replacements.
Details spark plug specifications and replacement procedures.
Explains inspection and maintenance of the front disc brake system.
Covers checking and refilling brake fluid levels.
Details inspection and adjustment procedures for the drum brake system.
Covers engine oil level checks, oil replacement, and oil strainer cleaning.
Details the removal, inspection, and re-assembly of the oil pump.
Explains gear oil level inspection and replacement procedures.
Step-by-step instructions for removing the motorcycle's carburetor.
Guides on adjusting the engine's idle speed and air/fuel mixture.
Lists safety and operational guidelines for engine removal.
Step-by-step instructions for safely removing the engine from the motorcycle.
Provides instructions for reinstalling the engine onto the motorcycle frame.
Lists torque values for cylinder head and valve train components.
Helps diagnose issues related to rough idle, low/high compression, and noise.
Step-by-step guide for removing the camshaft from the cylinder head.
Provides instructions for removing the cylinder head assembly.
Covers the process of disassembling the cylinder head and its components.
Covers inspecting, grinding, and servicing valve seats.
Guides on reassembling the cylinder head after service.
Provides steps for installing the cylinder head onto the engine block.
Details the correct procedure for installing the camshaft.
Explains how to adjust valve clearance using a feeler gauge.
Step-by-step instructions for removing the cylinder from the engine.
Guides on removing the piston and piston rings from the cylinder.
Explains the correct procedure for installing piston rings into their grooves.
Details the process for installing the piston into the cylinder.
Provides instructions for reinstalling the cylinder onto the crankcase.
Explains the removal, inspection, and installation of the drive belt.
Covers the removal, inspection, and assembly of the sliding pulley.
Details the disassembly and inspection of the clutch and driven pulley.
Covers the installation of the clutch/driven pulley assembly.
Step-by-step guide for disassembling the final drive mechanism.
Provides instructions for reassembling the final drive mechanism.
Step-by-step guide for removing the A.C. generator assembly.
Step-by-step guide for disassembling the crankcase.
Details how to inspect the crankshaft for clearance and run-out.
Provides instructions for reassembling the crankcase.
Helps diagnose issues with charging, ignition, and starting systems.
Details battery removal, installation, and safety precautions.
Covers ignition system circuits, CDI unit checks, and ignition coil testing.
To Next Page
General
