E-Z Style 1900EZ-26FP

Questions and Answers

S
Sandra MosesAug 11, 2025
What to do if E-Z Style 1900EZ-26FP remote control is not working?
- R
  Robert RiveraAug 11, 2025
  If your E-Z Style Indoor Fireplace remote control isn't working, first, replace the batteries. If that doesn't solve the issue, operate the remote at a slow, measured pace, pressing the buttons with an even motion and gentle pressure, as rapidly pressing buttons may cause a malfunction. Also, ensure you are within 20 feet of the appliance and pointing the remote at the control panel.
P
Philip GutierrezAug 17, 2025
Why E-Z Style 1900EZ-26FP Indoor Fireplace heater does not blow warm air?
- A
  Amanda MartinezAug 17, 2025
  There could be a couple of reasons why your E-Z Style Indoor Fireplace isn't blowing warm air. First, the cool-down cycle is a normal operation, and the unit will continue to run for several minutes with cool air before shutting down; the duration depends on the temperature. Alternatively, check your thermostat settings to ensure they are set higher than the current room temperature.
J
Jonathan WalkerAug 23, 2025
What to do if my E-Z Style Indoor Fireplace has no power and logs do not glow?
- T
  Tracie CarrAug 23, 2025
  If your E-Z Style Indoor Fireplace has no power and the logs aren't glowing, ensure the unit is plugged into a standard 120V outlet and that the power is set to the “ON” position. Try pressing the power button several times.
K
Karen BurnsAug 29, 2025
How to fix E-Z Style 1900EZ-26FP Indoor Fireplace displaying “E2/E3” error?
- A
  Anthony RogersAug 29, 2025
  If your E-Z Style Indoor Fireplace display shows “E2/E3”, it indicates a problem with the thermostat sensor. Inspect the heater, ensuring the air inlets and outlets are not blocked, as this can cause overheating. Unplug the heater for 30 minutes to allow it to cool down, then replug and monitor for overheating. If the problem persists, stop using the heater and contact customer service.
C
Collin RamseySep 3, 2025
What to do if E-Z Style 1900EZ-26FP logs glow, but there is no flame effect?
- J
  Jessica RuizSep 4, 2025
  If the logs of your E-Z Style Indoor Fireplace glow, but there is no flame effect, press the flame button several times.

E-Z Style 1900EZ-26FP Specifications

General

Model	1900EZ-26FP
Category	Indoor Fireplace
Fuel Type	Electric
Heating Capacity	400 sq ft
Voltage	120V
Remote Control	Yes
Thermostat	Yes
Safety Features	Overheat Protection

E-Z Style 1900EZ-26FP - User Manual

Table of Contents

Questions and Answers

E-Z Style 1900EZ-26FP Specifications