Eachine NOVICE-II - Flight Controls and Stick Operations; Left Stick Controls; Right Stick Controls; Lipo Battery Charging

Toggle SWC(AUX2) switch to select flight mode (Default is Acro mode)
Always use caution when flying and operate in an open and controllable area.
Please learn the flight controls first before powering on the aircraft to fly. The
left stick controls throttle and yaw direction of NOVICE-II. The right stick
controls pitch and roll of the aircraft.
Left Stick Diagram
5. Flight and Radio Stick Controls
Right Stick Diagram
Ports are numbered 1-6. Do not put more than one battery on a single
port. For example: do not insert one battery on the Picoblade 1.25 plug
and another on the same port with the PH 2.0 plug.
4. Charger the Lipo Batter y
1. The belowing content are regarding the advanced tutorial. The drone
comes out already finished all the settings and bound with the radio .
2. Don't mod to XT30 Plug , it will burnt the flight controller if mod to xt30
and use high discharge rating battery .
-2-
6. Flight controller connection diagram
GND
+5V
Video_in
M1
M2
M3
M4
Video_out
USB
TX2
RX2
LED
BUZ-
RX1
IR1
TX1
BOOT
BIND
+5V output
GND
LIPO_IN
1-2S
GND
1.Plug the usb and go to the CLI command tab in the betaflight configurator,
then type “bind_rx_spi”,the receiver will getting into bind mode , and then
make your Flysky radio to bind mode.
7. Binding procedure
2.Please Ensure the RX setup of your transmitter is in AFHDS 2A Mode. Then
get your transmitter into binding mode： Turn on the transmitter while
holding the bind button. The White and red LED on the flight controller
should blinking fast first and then blinking slowly, this indicates binding
successfully. Now you need to exit binding mode of the transmitter and
re-connect the Novice-II to the computer, then the Red and white LED should
be getting to be solid , this indicates the connection was established between
the NOVICE-II and your transmitter.
Important notice:
Charging currents switchCharging currents switchCharging currents switch
2-6S Lipo Input
DC 12V Input
Solid LED---Charging
LED OFF---Charging complete
USB 5V out
4.2V/4.35V charging switch
Throttle up
Left Side View
Climb
Throttle down
Descend
Left Side View
Yaw Left
Nose Yaws Left
Yaw Right
Nose Yaws Right
Pitch Down
Left Side View
Forward
Pitch Up
Backward
Left Side View
Roll Left
Left
Rear View
Roll Right
Rear View
Right
NOVICE-II 1-2S Brushless Micro Drone
LIPO_IN
GNDGNDGND
BUZ-
TX2
LED
BOOT
BIND
GND
+5V
Video_in
Video_outVideo_outVideo_out
M4
M3
M2
M1
USB
GND
BUZZ+
5
Position1 Acro modePosition1 Acro mode
Position2 Stable modePosition2 Stable mode
Position3 Air modePosition3 Air mode
Position1 Acro mode
Position2 Stable mode
Position3 Air mode
-Solid: Normal work
-Blinking fast: Bind mode
-Blinking slowly: Bind
successful or no RC Signal